Grand Cherokee 2WD V6-3.7L (2008)
Solar Sensor: Description and Operation
Operation
OPERATION
The infrared sensor detects thermal radiation emitted by the driver and front passenger seat occupants and their surroundings and converts its data into a
linear pulse width modulated (PWM) output signal which is read by the automatic temperature control (ATC) A/C-heater control. The ATC A/C-heater
control uses the infrared sensor data as one of the inputs necessary to automatically control the interior cabin temperature level. By using thermal
radiation (surface temperature) measurement, rather than an air temperature measurement, the ATC heating-A/C system is able to adjust itself to the
comfort level as perceived by the occupant. This allows the ATC system to compensate for other ambient conditions affecting comfort levels, such as
solar heat gain or evaporative heat loss.
The ATC system logic responds to the infrared sensor message by calculating and adjusting the air flow temperature and air flow rate needed to properly
obtain and maintain the selected comfort level temperature of the occupants. The A/C-heater control continually monitors the infrared sensor circuits,
and will store diagnostic trouble codes (DTCs) for any problem it detects.
The infrared sensor is diagnosed using a scan tool See: Heating and Air Conditioning/Testing and Inspection/Component Tests and General
Diagnostics/Heating-A/C System Diagnostics.
The infrared sensor cannot be adjusted or repaired and the entire ATC A/C-heater control must be replaced if found inoperative or damaged.
