Grand Cherokee 2WD V8-4.7L VIN J (2004)
Fig. 25 Driver Airbag Trim Cover Locking Blocks Engaged
3. Engage the upper and lower trim cover locking blocks with the lip of the driver airbag housing, then engage the locking blocks on each side of the
trim cover with the lip of the housing. Be certain that each of the locking blocks is fully engaged on the lip of the airbag housing.
4. Reinstall the horn switch ground pigtail wire eyelet terminal over the upper right inflator stud on the back of the driver airbag housing.
5. Reinstall the upper and lower airbag trim cover retainers over the inflator studs on the back of the driver airbag housing. Be certain that the tabs on
each retainer are engaged in the slots of the upper and lower trim cover locking blocks.
6. Install and tighten the four nuts that secure the trim cover retainers to the inflator studs on the back of the driver airbag housing. Tighten the nuts to
7 Nm (60 in. lbs.).
7. Engage the horn switch feed pigtail wire connector retainer in the mounting hole in the upper trim cover retainer.
8. Reinstall the driver airbag onto the steering wheel.
