Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Speaker: Service and Repair
Rear Door
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the bezel near the inside door latch release handle by inserting a straight-bladed screw-driver in the notched end of the bezel and prying
gently upwards.
Rear Door Trim Panel Remove/Install
3. Remove the screw located beneath the bezel that secures the rear door trim panel to the inner door panel.
4. Remove the trim cap and screw near the rear of the rear door armrest.
5. Using a trim stick or another suitable wide flat-bladed tool, gently pry the rear door trim panel away from the door around the perimeter to release
the trim panel retainers.
NOTE: To aid in the removal of the trim panel, start at the bottom of the panel.
6. Pull the rear door trim panel away from the inner door panel far enough to access and unplug the wire harness connector from the power window
switch.
Rear Door Speaker Remove/Install
7. Remove the three screws that secure the speaker to the lower front corner of the inner door panel.
8. Pull the speaker away from the inner door panel far enough to access and unplug the speaker wire harness connector.
9. Remove the speaker from the door.
10. Reverse the removal procedures to install. Tighten the hardware as follows:
-
Speaker mounting screws - 1.1 N.m (10 in. lbs.)
-
Trim panel mounting screws - 1.3 N.m (12 in. lbs.).
