Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Steering Control Module: Service and Repair
Disassembly and Assembly
MODULE-STEERING CONTROL
DISASSEMBLY
1. With the SCM (4) removed, remove the hazard switch by releasing the tangs (2) and sliding the switch (1) out of position.
2. Remove the two screws (1) for the right multi-function (wiper/washer) switch (2). The left multi-function (lighting control) switch will be mounted
on the left side of the SCM the exact same way. The connectors are integral to the SCM and are self docking.
3. Using a trim stick (special tool #C-4755) or equivalent, gently pry in on the three tabs holding the turn signal cancel cam to the SCM. You must go
in through the front of the SCM to release the tabs. Be careful not to break tabs if reusing the cancel cam for they are brittle.
ASSEMBLY
