jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Recall - Steering Shaft|Page 5286 > < Recall - Steering Shaft|Page 5284
Page 4
background image

Note:

If there is not enough length for the sleeve to fit on the intermediate shaft, use a screwdriver placed against the upper boss of the intermediate shaft to
gently work the lower steering column shaft back up into the column as shown in Figure 3. Then, install the sleeve.

3.

Install the tie strap around the sleeve and position it in the center notched-out area of the sleeve (Figure 2). Cut off the free end of the tie strap.

4.

Reinstall the stone shield.

Completion Reporting and Reimbursement

Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.

Use the labor operation number and time allowance (see illustration).

Add the cost of the recall parts package plus applicable dealer allowance to your claim.

Note:

See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing instructions.

Parts Return

Not applicable.

Vehicle Not Available

Recall - Steering Shaft|Page 5286 > < Recall - Steering Shaft|Page 5284