Grand Cherokee 4WD L6-4.0L VIN S (1997)
Fig. 48 Key Cylinder - Rear View
Fig. 49 Installing Key Cylinder Into Switch
2. With key into ignition key cylinder, rotate key clockwise until retaining pin can be depressed.
3. Install key cylinder into ignition switch by aligning retaining pin into retaining pin slot. Push key cylinder into switch until retaining pin engages.
After pin engages, rotate key to OFF or LOCK position.
4. Check for proper retention of key cylinder by attempting to pull cylinder from switch.
12. Install steering column covers (shrouds). Tighten screws to 2 Nm (17 in. lbs.) torque.
13. Install tilt column lever (if equipped).
14. Connect negative cable to battery
15. Check for proper operation of halo light.
16. Automatic Transmission Only: Shifter should lock in PARK position when key is in LOCK position (if equipped with shift lock device). Shifter
should unlock when key rotated to ON position.
17. Check for proper operation of ignition switch in ACCESSORY, LOCK, OFF ON, RUN, and START positions.
18. Steering wheel should lock when key is in LOCK position. Rotate steering wheel to verify Steering wheel should unlock when key is rotated to ON
position.
