Liberty 2WD V6-3.7L (2008)
9. Remove the lower ball joint nut.
10. Separate the lower ball joint from the suspension arm using tool C-4150A (3).
11. Remove the upper ball joint nut.
12. Separate the upper ball joint from the knuckle using tool 9360 (2).
NOTE: Inspect the seal side surface of the upper ball joint, lower ball joint & outer tie rod knuckle bosses. If any significant grooves or
gouges are present (or heavily scratched) Replace the steering knuckle.
13. Remove the knuckle (3) from the vehicle.
14. Remove the hub/bearing. (if needed)See: Wheel Bearing/Service and Repair/Front Hub / Bearing - Removal.