Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches that secure the
B(+) terminal module in the PDC.
3. Gently and evenly press the two B(+) terminal studs down through the bus bar in the PDC.
4. From the bottom of the PDC housing, remove the B(+) terminal module from the PDC.
PDC RELAY WEDGE
REMOVAL
The Power Distribution Center (PDC) cover, the PDC housing lower cover, the PDC relay wedges, the PDC mini fuse wedge, the PDC relay cassettes
and the PDC B(+) terminal stud module are available for service replacement. The PDC cover can be simply unlatched and removed from the PDC
housing without the PDC being removed or disassembled. Service of the remaining PDC components requires that the PDC be removed from its
mounting and disassembled. Refer to Wiring Repair in Wiring Diagrams for the location of the wiring repair procedures.
1. Remove the PDC housing lower cover.
2. Remove each of the relays from the PDC relay wedge to be removed.
3. From the bottom of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches (yellow)
that secure the relay wedge to the PDC relay cassette.
PDC Relay Wedge Remove/Install - Typical
4. From the top of the PDC housing, remove the relay wedge from the PDC relay cassette.
PDC RELAY CASSETTE
REMOVAL
The Power Distribution Center (PDC) cover, the PDC housing lower cover, the PDC relay wedges, the PDC mini fuse wedge, the PDC relay cassettes
and the PDC B(+) terminal stud module are available for service replacement. The PDC cover can be simply unlatched and removed from the PDC
housing without the PDC being removed or disassembled. Service of the remaining PDC components requires that the PDC be removed from its
mounting and disassembled. Refer to Wiring Repair in Wiring Diagrams for the location of the wiring repair procedures.
1. Remove the relay wedge from the PDC relay cassette to be removed.
NOTE: It may be necessary to remove relay cassettes that are not being serviced from the PDC housing in order to obtain sufficient clearance to
access the faulty relay cassette. The same service procedure is repeated as necessary to remove each of the interfering relay wedges and relay
cassettes from the PDC housing.
