Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
8. Apply grease to the housing bore (4) (Fig. 28) then install the bearing assembly (2) into the housing (1).
9. Install the housing snap-ring (3) and verify it is seated in the groove.
10. Fill the housing and boot with the remaining grease.
11. Slide the boot onto the C/V housing into it's original position. Ensure boot is not twisted and remove any excess air.
12. Secure both boot clamps with Clamp Installer C-4975A. Place tool on clamp bridge and tighten tool until the jaws of the tool are closed.
