Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
INSTALLATION
1. Install the trough guides.
2. Install the drive motor.
3. Install the sunshade.
4. Remove the backing tape from the foam support pad, if necessary.
5. Raise rear end of sunroof module assembly and guide into position and start fasteners.
6. Tighten the fasteners to 9 N.m (80 in. lbs.).
7. Connect the drain tubes.
8. Install the wire harness.
9. Connect battery negative cable.
10. Temporarily install sunroof switch and perform the sunroof motor teach procedure.
11. Test sunroof operation, adjust glass as necessary.
12. Install the headliner.
13. Install the opening trim lace.
