Liberty 4WD V6-3.7L (2009)
13. Manually position the rear drive assembly about 300 mm (12 inches) open, See:
14. Position the rear of the cover down over the rear drive (1) and seat fully.
15. Install the five screws (2).
16. Line up the headliner (3) center notch with the center screw (2) and seat the headliner hook and loop strip (3) fully.
17. Install the front drive assembly. See: Front Drive Assembly - Installation
Motor Mounting Plate - Removal
REMOVAL
NOTE: Both motor mounting plates must be removed when servicing one or the other. It is necessary to remove both plates in order to
remove the rivet pieces from the roof rail.
1. Drop headliner down as needed to gain access to the motors, See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Removal.
2. Disconnect the large module electrical connector.
3. Manually position the front drive assembly about 300 mm (12 inches) open, See:
4. Separate the headliner hook and loop strip (3) and expose the drive mechanism.
5. Remove the five screws (2) and separate the cover assembly from the drive (1).
