Liberty 4WD V6-3.7L (2009)
Power Distribution Module: Service and Repair
Totally Integrated Power Module (TIPM) - Installation
INSTALLATION
CAUTION: The original Cabin Compartment Node (CCN) and Powertrain Control Module (PCM) must be installed and functioning properly
prior to powering up the new Totally Integrated Power Module (TIPM). The TIPM receives vehicle configuration data from the
CCN and Vehicle Identification Number (VIN) information from the PCM. If configuration information becomes lost or
corrupted, the data can be obtained from DealerCONNECT
1. Position the TIPM into the engine compartment.
2. Connect each of the seven TIPM wire harness connectors in the order shown.
3. Position the TIPM (1) onto the mounting bracket (2) and push down until the four mounting clips are fully seated onto the mounting tabs (3).
