Liberty 4WD V6-3.7L (2009)
3. Using a trim stick or another suitable wide flat-bladed tool, gently pry the seat back recliner handle (1) to release the spring clip (2) and remove
the handle from the recliner mechanism shaft at the rear of the outboard seat side shield. Optionally, a manual window regulator handle clip
removal tool may be used to remove the spring clip from the handle before removing the handle from the recliner mechanism shaft.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the rear edge of the seat belt anchor cover to remove it from the outboard
seat side shield.
5. Remove the screw that secures the lower anchor to the outboard side of the front seat cushion frame.
6. Remove the upper trim (3) from the inside of the B-pillar (7). See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel-Removal.
7. Remove the screw that secures the seat belt turning loop (2) to the height adjuster (1) on the upper B-pillar.
8. Remove the seat belt turning loop from the height adjuster.
9. Remove the lower trim (4) from the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel-Removal.
10. Disconnect the body wire harness connector (5) from the seat belt tensioner pigtail wire connector.
11. Remove the screw that secures the lower retractor (6) bracket to the B-pillar.
12. Disengage the engagement tab on the upper retractor bracket/seat belt web guide from the engagement slot in the B-pillar.
13. Remove the front seat belt and retractor from the B-pillar as a unit.
Second Row Center
SECOND ROW CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
