Liberty 4WD V6-3.7L (2009)
8. Position the front seat belt (2) lower anchor to the outboard side of the front seat (1) cushion frame. Be certain that the seat belt webbing between
the turning loop and the lower anchor is not twisted.
9. Install and tighten the screw (3) that secures the lower anchor to the front seat cushion frame. Tighten the screw to 44.5 Nm (33 ft. lbs.).
10. Insert the engagement tab of the seat belt anchor cover into the front of the opening near the rear of the outboard seat side shield. Using hand
pressure, press firmly and evenly on the rear of the cover until it snaps into place.
11. Align the seat back recliner handle (4) to the recliner mechanism shaft near the rear of the outboard seat side shield. Using hand pressure, press
firmly and evenly on the handle until it snaps into place.
12. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Service and Repair.
Second Row Center
SECOND ROW CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
NOTE: All seat belt retractors except the driver side front and the second row center retractor include a switchable automatic locking
mechanism. See: Description and Operation/Seat Belt Retractor - Description .
NOTE: The anchor plates for the left outboard second row seat belt buckle and the second row center seat belt anchor are secured to each
other by a soft metal grommet as an assembly aid during the manufacturing process and, once removed, the grommet does not require
