Patriot 2WD L4-2.0L (2008)
8. Remove the mode door cable (1) from the right side of the air distribution housing (2) See: Air Door/Air Door Cable/Service and
Repair/Cable-Mode Door/Removal.
9. Remove the screw and washer (3) that secure the mode door cam (4) to the air distribution housing and remove the cam.
NOTE: If any foam seal on the air distribution housing outlets is deformed or damaged, the seal must be replaced.
10. Carefully cut the two foam seals (1) along the parting line (2) of the two halves of the air distribution housing (3). If either seal is deformed or
damaged, it must be replaced.
11. Remove the five screws (4) and one metal clip (5) that secure the two halves of the air distribution housing together.
12. Disengage the three plastic retaining tabs (6) that secure the two halves of the air distribution housing together and carefully separate the housing.
