Wagoneer L4-150 2.5L VIN E TBI (1990)
3.
Grasp the low pressure hose at the reservoir end and pull the hose through the outer mesh sleeve. Remove the hose from the vehicle
(Figure 11).
4.
Pull the large diameter mesh sleeve off the high pressure hose.
5.
From the ABS Service Parts Package, obtain the steel low pressure tube assembly with two foam sleeves attached. This tube will be
routed along the dash panel behind the engine valve cover. The tube will pass behind everything along the dash panel.
6.
Position the tube starting at the driver's side of the vehicle in the area where the master cylinder was removed, (Figure 12). The end of
the tube with the 90~ bend should be routed behind the engine first. Leave the rubber caps on the tube to prevent dirt and/or paint chips
from entering the tube.
7.
Work the tube behind the wiring harnesses and along the dash panel toward the passenger side of the vehicle. Do not force or bend the
tube. The pump end of the tube will be positioned between the vapor canister and the "H"-valve, (Figure 13).
8.
Take the "S" shaped hose and two of the larger diameter hose clamps from the parts package.
9.
From the passenger side of the vehicle, place a clamp over the straight end of the hose, oriented so that the screw portion of the clamp is
on the bottom.
10.
Remove the cap from the end of the tube.
