Wagoneer L6-242 4.0L VIN M FI (1988)
FIGURE 5
5.
Separate the O(2) sensor heater relay (H-Fig. 5) and holder from the rest of the relays.
NOTE:
The oxygen O(2) sensor heater relay may be identified as the only relay with a gray wire.
6.
Remove the O(2) relay from its holder.
7.
Pry the white plastic retaining clip (J-Fig.5) from the relay holder.
FIGURE 6
8.
Insert a paper clip into cavities 1 and 5 (Fig. 6) from the relay side, to release the locking tab of the terminals. Switch the wires in the cavity holes,
orange wire goes into cavity 1 and the yellow wire goes into cavity 5.
9.
Install the white plastic retaining clip.
10.
Install the O(2) relay into the relay holder.
11.
Attach the O(2) relay assembly to the other three relay assemblies and install them to the fender bracket.
12.
Connect the battery negative cable.
Parts & SRT/Tic Information & Filing Instruction
PARTS INFORMATION
DESCRIPTION
QUANTITY
PART NUMBER
KIT Resistor
1
8983 100 054
