Wrangler L4-2.4L VIN 1 (2006)
Fig. 46 PINION ROTATING TORQUE
6. With yoke Spanner Wrench 6958 and a torque wrench set at 678 Nm (500 ft. lbs.), slowly tighten nut (Fig. 45) in 6.8 Nm (5 ft. lbs.) increments
until rotating torque is achieved. Measure rotating torque with inch pound torque wrench frequently to avoid over crushing the collapsible spacer
(Fig. 46).
CAUTION: If more than 687 Nm (500 ft. lbs.) torque is required to crush the collapsible spacer, the spacer is defective and must be replaced.
Failure to heed caution may result in damage.
7. Rotating torque should be the recorded reading during removal, plus an additional 0.56 Nm (5 inch lbs.).
8. Install propeller shaft.
9. Install brake rotors and calipers.
