Wrangler L4-2.5L VIN P (1999)
Power Distribution Center: Service and Repair
The Power Distribution Center (PDC) is serviced as a unit with the dash wire harness. If any internal circuit of the PDC or if the PDC housing is faulty or
damaged, the entire PDC and the dash wire harness unit must be replaced.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Disconnect each of the dash wire harness connectors.
3. Remove all of the fasteners that secure each of the dash wire harness ground eyelets to the vehicle body and chassis components.
4. Disengage each of the retainers that secure the dash wire harness to the vehicle body and chassis components.
Power Distribution Center Connections
5. Unlatch and remove the terminal stud cover from the rearward end of the PDC.
6. Remove the nut that secures the eyelets of the battery positive cable take out and the engine wire harness take out to the stud on the PDC.
7. Remove the battery positive cable take out and the engine wire harness take out eyelets from the PDC stud.
Power Distribution Center Remove/Install
8. Disengage the latches on the PDC mounting bracket from the tabs on the PDC housing, and pull the PDC housing upward to disengage the
mounting slots from the stanchions of the mounting bracket.
9. Remove the PDC and the dash wire harness from the engine compartment as a unit.
