Wrangler L6-4.0L VIN S (2000)
4. Position the multi-function switch onto its mounts on the left side of the steering column. If the vehicle is equipped with the optional tilt steering
column, lifting gently upward on the tilt release lever will provide additional clearance to ease multi-function switch installation.
5. Position the lower mounting tab of the multi-function switch water shield bracket to the steering column screw boss below the multi-function
switch control stalk.
6. Install and tighten the one screw located below the multi-function switch control stalk that secures the multi-function switch water shield and
bracket to the steering column. Tighten the screw to 1.1 Nm (10 in. lbs.).
7. Install and tighten the two screws that secure the multi-function switch water shield and bracket to the top of the steering column. Tighten the
screws to 2.2 Nm (20 in. lbs.).
8. Position both the upper and lower shrouds onto the steering column.
9. Install and tighten the three screws that secure the lower steering column shroud to the upper shroud. Tighten the screws to 2 Nm (18 in. lbs.).
10. If the vehicle is so equipped, tighten the two nuts that secure the non-tilt steering column upper mounting bracket to the dash panel steering
column support bracket studs. Tighten the nuts to 22 Nm (200 in. lbs.)
11. Install the knee blocker onto the instrument panel. Refer to Airbags and Seat Belts/Airbags (SRS)/Knee Diverter/Service and Repair.
12. Reconnect the battery negative cable.