Borrego 4WD V6-3.8L (2009)
Stabilizer Bar: Service and Repair
Rear Stabilizer Bar
Replacement
1. Remove the rear wheel & tire.
Tightening torque:
90 - 110N.m (9.0 - 11.0kgf.m, 65 - 80lb-ft)
2. Remove the fuel tank.
3. Loosen the bolt from the propeller shaft.
4. Remove the stabilizer from the stabilizer link.
5. Remove the bolt form the stabilizer.
Tightening torque:
A, B: 100 - 120N.m (10.0 - 12.0kgf.m, 72 - 87lb-ft)
C: 45 - 55N.m (4.5 - 5.5kgf.m, 33 - 40lb-ft)
6. Remove the stabilizer bar.
7. Installation is the reverse of the removal.