Borrego 4WD V6-3.8L (2009)
5. Remove the tie rod end ball joint from the knuckle.
(1) Remove the split pin(A).
(2) Remove the castle nut(B).
(3) Disconnect the ball joint(C) from knuckle using the special tool (09568-4A000).
Tightening torque :
58.8 - 78.4N.m(6.0 - 8.0Kgf.m, 43.3 - 57.8lb.ft)
CAUTION:
Apply a few drops of oil to the special tool. (Boot contact part)
6. Remove the wheel speed sensor(A), the strut lower mounting bolt(B) and the lower arm mounting bolt(C) from the knuckle.
Tightening torque :
6.8 - 10.8N.m( 0.7 - 1.1Kgf.m,5.1 - 7.9lb.ft)
Tightening torque :
137.2 - 156.9N.m(14 - 16Kgf.m, 101.2 - 115.7lb.ft)
