Forte L4-2.0L (2010)
CAUTION:
Apply a few drops of oil to the special tool. (Boot contact part)
7. Remove the wheel speed sensor(B).
Tightening torque:
6.8 - 10.8N.m( 0.7 - 1.1Kgf.m,5.1 - 7.9lb.ft)
8. Remove the lower arm from the knuckle.
(1) Remove the split pin(A).
(2) Remove the castle nut(B).
(3) Disconnect the lower arm(C) from knuckle using the special tool (09568-4A000).
CAUTION:
Be careful not to damage the boot and rotor teeth.
9. Disconnect the driveshaft (A) from the front hub assembly.
10. Insert a pry bar between the transaxle case and joint case(A), and separate the drive shaft from the transaxle case.
