Rio L4-1.6L (2004)
8. Remove the stabilizer bar from the control link after loosening the control link nut.
9. Separate the driveshaft from the transaxle.
NOTE: Separate the shaft by pulling the hub outward. Do not use too much force at once, increase the force gradually. (If the shaft is pulled out
too quickly, the oil seal may be damaged.)
10. Remove the driveshaft lock nut and discard.
11. Pull the driveshaft out of the wheel hub.
NOTE: Be especially careful not to damage the oil seal at this time.
12. Pull the driveshaft out of the transaxle. Discard the circlip.
13. Install the differential side gear holder into the transaxle to fix the side gear.
INSTALLATION
1. Install a new circlip on the inboard halfshaft end.
2. Lubricate the inboard end of the halfshaft with grease.
