Rondo V6-2.7L (2009)
12. Pull the rack bar (A) out of the rack housing.
Reassembly
REASSEMBLY
1. Apply the grease to rack gear teeth and then insert the rack bar (A) into the rack housing.
2. Apply the sealant to the thread of rack bush (A) and then install it to rack housing.
Tightening torque Nm (kgf.m, lb-ft):
100 - 120 (10.0 - 12.0, 72 - 87)
3. Apply the power steering fluid to the bearing (A) and then install it to the valve assembly.
4. Insert the pinion assembly (A) into the pinion housing. Tap the top of the pinion assembly with a plastic hammer to seat the pinion assembly
thoroughly.