Rondo V6-27L (2009) Steering Gear Removal and Replacement
5. Install a new oil seal to valve assembly.
6. Tighten the pinion lock nut (B).
Tightening torque Nm (kgf.m, lb-ft):
40 - 50 (4.0 - 5.0, 29 - 36)
7. Apply the sealant the thread of pinion plug (A) and then install it.
Tightening torque Nm (kgf.m, lb-ft):
45 - 55 (4.5 - 5.5, 33 - 40)
8. Install the snap ring (A) to the pinion housing.
9. Install the dust packing (A) and cap (B).
10. Insert the support yoke (D) and yoke spring (C) into the rack housing.
11. Apply the sealant to the thread of yoke plug (B) and then install it to the rack housing.
12. Torque the yoke plug to approx 20Nm (2kgf.m, 14lb-ft) and then loosen it.