Rondo V6-2.7L (2009)
13. Torque the yoke plug to 5 - 6Nm (0.5 - 0.6, 3.6 - 4.3lb-ft) again, and then loosen it by approx 35°.
14. Tighten the lock nut (A) while holding the yoke plug.
Tightening torque Nm (kgf.m, lb-ft):
50 - 60 (5.0 - 6.0, 36 - 43)
15. Apply the sealant to the thread (A) of tie-rod ball joint and then install it to the rack bar.
Tightening torque Nm (kgf.m, lb-ft):
120 - 140 (12.0 - 14.0, 87 - 101)
16. Assemble new bellows band (A) to the bellows.
17. Apply the grease to the portion (D) of the tie-rod.
18. Apply the sealant to the bellows mating surface of the rack housing.
19. Assemble the bellows (C) to rack housing and then tighten the bellows clip (A) and band (B).
20. Assemble the lock nut (A) and tie rod end (B) to tie rod.
