Sorento 2WD V6-3.8L (2007)
5. Set the center position by getting marks between the clock spring and the cover into line. Make an array the mark (> <) by turning the clock spring
clockwise to the stop and then 2.4 revolutions counterclockwise.
6. Install the steering wheel column cover and the steering wheel.
7. Connect the Driver Airbag (DAB) module connector and horn connector, then install the Driver Airbag (DAB) module on the steering wheel.
8. Secure the Driver Airbag (DAB) with the new mounting bolts.
Tightening torque (DAB Mounting Bolt): 0.8 - 1.1 kgf.m (7.9 - 10.8 Nm, 5.8 - 8.0 lb.ft)
9. Connect the battery negative cable
10. After installing the airbag, confirm proper system operation:
-
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
-
Make sure horn button works.
Air Bag Module (Passenger Side)
AIR BAG MODULE
AIR BAG MODULE (PASSENGER SIDE)
REMOVAL
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2. Remove the glove box.
3. Remove the PAB mounting bolts (2EA).
