Discovery II (LT) V8-4.0L (2002)
/v8-4.0l/Page-470003.png)
6. Apply sealant, Part Number STC 50552 to threads of timing cover bolts, fit bolts and working in sequence the sequence illustrated, tighten to 22
NM (17 lbf.ft). Ensure the camshaft position sensor (CMP) multiplug bracket is secured by the bolt
7. Fit new 'O' ring to oil cooler pipe, connect pipe to timing gear cover and tighten union to 15 Nm (11 ft. lbs.).
8. Connect Lucar to oil pressure switch.
9. Connect multiplug to CMP sensor.
10. Connect coolant hose to coolant pump and secure with clip.
11. Ensure mating faces of PAS pump pulley and drive flange are clean, fit pulley and tighten bolts to 22 Nm (16 ft. lbs.).
12. Remove all traces of thread locking material from coolant pump pulley drive flange bolt holes using an M8 tap.
13. Ensure mating faces of coolant pump pulley and drive flange are clean, fit pulley and tighten new Patchlok bolts to 22 Nm (16 ft. lbs.).
14. Ensure mating faces of oil filter and adaptor are clean, smear clean engine oil onto seal and fit filter.
15. Fit timing gear cover oil seal.
16. Fit oil pick-up strainer.
17. Refill cooling system.
