Freelander Service Procedures
MANIFOLDS & EXHAUST SYSTEMS - K SERIES KV6
30-3-4
REPAIRS
Intermediate pipe - Non NAS
$% 30.10.11
Remove
1. Raise vehicle on 4 post ramp.
2. Loosen tail pipe clamp nut and release tail pipe
from intermediate pipe.
3. Remove 3 nuts securing front pipe to
intermediate pipe.
4. Release intermediate pipe from front pipe.
5. Remove and discard gasket.
6. Release rubber mounting from intermediate
pipe.
7. With assistance release and remove
intermediate pipe.
Refit
1. Clean intermediate pipe/silencer, front pipe and
tail pipe mating faces.
2. Fit new gasket to front pipe flange.
3. With assistance fit intermediate pipe to tail pipe
and front pipe.
4. Fit nuts to intermediate pipe flange and tighten
to 60 Nm (44 lbf.ft).
5. Tighten tail pipe clamp nut to 55 Nm (41 lbf.ft).
6. Fit intermediate pipe to rubber mounting.
7. Lower vehicle.