landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Power steering pressure test - V8|Page 523 > < Power steering pressure test - Td6
Page 432
background image

STEERING

ADJUSTMENTS

57-5

6. Fit adaptor LRT-57-035 to existing high 

pressure hose.

7. Fit hose LRT-57-002 to each adaptor.
8. Fit pressure gauge LRT-57-005 to test valve 

LRT-57-001

9. Connect hoses LRT-57-002 to LRT-57-001 

and tighten unions.

10. Connect battery earth lead.
11. Ensure steering system and test equipment are 

free from leaks.

12. Maintain maximum fluid level during test.
13. With the test valve open, start the engine.
14. With the engine at idle, slowly turn the steering 

wheel and hold on full lock.

15. Repeat procedure for other lock.
16. Record pressure reading.
17. With the engine at idle , release the steering 

wheel. Pressure should read  below 7 bar.

18. Pressures outside the above tolerance 

indicates a fault.

19. To determine if fault is in steering pump or 

steering rack, close the test valve for a 
maximum of 5  seconds.

CAUTION: Pump damage will occur if test 
valve is closed for longer periods.

20. If figures recorded fall outside the values given 

in General Data, replace the PAS pump.

21. If maximum pump pressure is correct, suspect 

the steering rack.

22. On completion stop engine, disconnect battery 

earth lead and siphon fluid from PAS reservoir.

23. Dismantle test equipment.
24. Clean PAS pump and pipe union.
25. Fit new 'O' ring to high pressure pipe, align to 

PAS pump and tighten union to 25 Nm. 

26. Connect battery earth lead.
27. Refill and bleed PAS system.

 

 + 

 STEERING, ADJUSTMENTS, Power 

assisted steering (PAS) system - bleed.

Power steering pressure test - V8 

$% 57.90.10.01 

Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 

 + 

 GENERAL INFORMATION, Electrical 

Precautions.

Check

1. Position vehicle on lift.
2. Disconnect battery earth lead.
3. Siphon PAS fluid from reservoir.
4. Remove undertray.

 

 + 

 EXTERIOR FITTINGS, REPAIRS, 

Undertray - front.

5. Position a suitable container below PAS pump.

6. Loosen union nut, disconnect PAS outlet hose 

from pump and discard 'O' ring.

7. Fit adaptor LRT-57-034A to high pressure port 

of PAS pump.

8. Fit adaptor LRT-57-035 to existing high 

pressure hose.

Power steering pressure test - V8|Page 523 > < Power steering pressure test - Td6