landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Power steering pressure test - V8 > < Steering geometry|Page 520
Page 431
background image

STEERING

57-4

ADJUSTMENTS

27. Loosen track rod end locknut.
28. Adjust by rotating track rod using hexagon on 

shaft. Do not allow gaiter to twist.

CAUTION: Both track rods must be rotated 
an equal amount.

29. Recheck front wheel alignment.
30. Tighten track rod end locknut to 55 Nm (40 

lbf.ft).

31. Connect battery earth lead.

Power steering pressure test - Td6 

$% 57.90.10.01 

Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 

 + 

 GENERAL INFORMATION, Electrical 

Precautions.

Check

1. Disconnect battery earth lead.
2. Siphon PAS fluid from reservoir.
3. Position absorbent cloth to catch spillage.
4. Loosen union securing high pressure pipe to 

PAS pump and release pipe.

CAUTION: Care must be taken to ensure 
that oil or fluid does not enter or 
contaminate the alternator.

5. Fit adaptor LRT-57-034A to high pressure port 

of PAS pump.

Power steering pressure test - V8 > < Steering geometry|Page 520