L322 Range Rover Service Procedures
ENGINE - V8
OVERHAUL 12-2-117
10. Release clip and disconnect drain hose from
inlet manifold. Discard clip.
CAUTION: Always fit plugs to open
connections to prevent contamination.
11. Remove induction manifold and discard 4
gaskets.
Reassembly
1. Fit new gaskets to inlet manifold.
2. Position inlet manifold, connect drain hose and
secure the hose with a new clip.
3. Fit inlet manifold to studs, fit spacers and
tighten nuts evenly and progressively to 15 Nm
(11 lbf.ft).
4. Connect purge control valve hose to inlet
manifold.
5. Connect engine breather hoses and tighten
hose clips.
6. Position engine breather separator to bracket
and tighten bolts to 6 Nm (4.4 lbf.ft).
7. Position SAI vacuum switch and reservoir to
inlet manifold, connect hose to inlet manifold
end cover.
8. Connect vacuum hose to SAI control valve.
9. Fit positive terminal to bracket on inlet manifold
and tighten nut to 10 Nm (7 lbf.ft).