L322 Range Rover Service Procedures
CHARGING AND STARTING
REPAIRS
86-1-1
CHARGING AND STARTING
REPAIRS
Alternator - Td6
$% 86.10.02
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
Remove
1. Disconnect battery earth lead.
2. Remove ancillary drive belt.
REPAIRS, Ancillary drive belt - Td6.
3. Remove 4 bolts securing PAS pump to
mounting, release pump and tie aside.
4. Remove Allen bolt securing ancillary drive belt
upper idler pulley and remove pulley.
5. Remove nut securing battery cable to
alternator, release cable and position aside.
6. Disconnect alternator multiplug.
7. Remove 2 bolts securing alternator to
mounting, collect idler pulley bracket and
remove alternator.
Refit
1. Position alternator to mounting bracket.
2. Fit jockey pulley carrier bracket and bolts to
alternator. Tighten bolts to 45 Nm (33 lbf.ft).
3. Connect alternator multiplug.
4. Connect battery cable to alternator, fit nut and
tighten to 13 Nm (10 lbf.ft).
5. Position upper ancillary drive belt jockey pulley,
fit and tighten bolt to 25 Nm (18 lbf.ft).
6. Position PAS pump to mounting and fit bolts.
Tighten M8 bolts to 25 Nm (18 lbf.ft) and M6
bolts to 10 Nm (7 lbf.ft).
7. Fit ancillary drive belt.
REPAIRS, Ancillary drive belt - Td6.
8. Connect battery earth lead.
M86 5654