L322 Range Rover Service Procedures
CHARGING AND STARTING
REPAIRS 86-1-11
4. Remove 4 bolts and battery carrier.
Refit
1. Fit battery carrier, ensure stud aligns with FBH
mounting bracket.
2. Fit bolts to carrier and nut to FBH mounting
bracket, tighten to 10 Nm (7 lbf.ft).
3. Fit and secure wheelarch liner.
4. Fit battery.
Starter motor - Td6
$% 86.60.01
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
Remove
1. Disconnect battery earth lead.
2. Remove air intake plenum.
3. Remove cable tie securing harness to dipstick
tube.
4. Release fuel hose clip from dipstick tube.
5. Remove dipstick.
6. Remove bolt securing dipstick tube.
7. Remove dipstick tube and discard 'O' ring.
8. Release positive cable clip from inlet manifold.
9. Remove 2 Torx bolts and release starter motor
for access to electrical connections.
M86 5637
M86 5645