L322 Range Rover Service Procedures
CHARGING AND STARTING
86-1-6
REPAIRS
Tensioner - ancillary drive belt - Td6
$% 86.10.06
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
Remove
1. Disconnect battery earth lead.
2. Remove ancillary drive belt.
REPAIRS, Ancillary drive belt - Td6.
3. Remove alternator.
4. Remove Allen bolt, securing ancillary belt idler
and remove idler from vehicle.
5. Remove nut, securing ancillary drive belt
tensioner arm to rear of spring housing.
6. Remove tensioner arm from mounting.
7. Remove and discard tensioner arm seal.
8. Remove 2 bolts securing ancillary drive belt
tensioner to lower timing gear cover.
9. Remove tensioner.
Refit
1. Clean tensioner block and mounting.
2. Position tensioner block, temporarily fit
tensioner arm to align spring block with timing
cover. Fit bolts and tighten to 25 Nm (18 lbf.ft).
Remove tensioner arm.
3. Clean seal mounting for tensioner arm on
timing cover, fit new seal.
4. Fit ancillary drive belt tensioner to timing cover,
push fully home. Fit new nut and tighten to 10
Nm (7 lbf.ft).
5. Fit alternator.
6. Fit idler pulley to mounting and tighten Allen
bolt to 25 Nm (18 lbf.ft).
7. Fit ancillary drive belt.
REPAIRS, Ancillary drive belt - Td6.
8. Connect battery earth lead.
M86 5742
M86 5643