L322 Range Rover Service Procedures
SCREENS
REPAIRS
76-4-1
SCREENS
REPAIRS
Glass - tailgate upper
$% 76.31.22
The following equipment is required:
l
Cutting wire and handles
l
Glazing knife
l
Glass replacement kit
l
Sealant applicator gun
l
Suction cups
l
A felt covered table or stand to support glass
Remove
1. Remove rear wiper arm.
2. Remove tailgate trim casing.
3. Remove tailgate inner side finishers.
4. Remove tailgate glass outer finisher.
5. Disconnect 3 multiplugs from tailgate glass.
6. Protect exterior body work adjacent to rear
screen.
7. From inside vehicle, carefully cut through
sealant securing lower edge of windscreen with
a glazing knife. It is not practical to use a Kent
knife as the windscreen is very close to body.
8. If necessary, use cutting wire to cut through any
remaining sealant securing top and sides of
windscreen.
9. Attach suction cups and with assistance,
remove windscreen and place on stand.
CAUTION: Lay glass on felt covered
supports and be careful not to damage the
obscuration band. Do not stand on edge as
this can cause chips which subsequently
develop into cracks.
10. Remove 2 windscreen support blocks from
body.