L322 Range Rover Service Procedures
SCREENS
76-4-6
REPAIRS
Glass - quarter light - rear
$% 76.81.20
The following equipment is required:
l
Cutting wire and handles
l
Kent knife
l
Glass replacement kit
l
Sealant applicator gun
l
A felt covered table or stand to support glass
Remove
1. Remove 'E' post finisher.
2. Remove quarter light front finisher.
3. Remove rear quarter trim access panel
4. Disconnect receiver multiplug from glass.
5. Protect exterior body work adjacent to quarter
light.
6. Protect internal trim adjacent to quarter light.
7. Carefully cut through and remove top and
bottom finishers to gain access to glass
sealant.
8. From outside of vehicle, use a Kent knife and
carefully cut through sealant securing quarter
light to body.
9. If necessary, use cutting wire to cut through any
remaining sealant.
10. Remove quarter light.
Refit
1. Carefully remove sealant from body to leave a
smooth surface.
2. Clean sealant face on body and quarter light
with solvent.
3. Apply etch primer to any bare metal on body.
4. Apply primer over etch primer.
5. Apply screen primer to sealant face on glass
and allow to cure.
6. Apply activator over old sealant on body and
allow to cure.
7. Fit pre-cut nozzle to sealer cartridge, remove
lid, shake out crystals and fit cartridge to
applicator gun. If necessary modify the nozzle
to achieve required bead section.
M76 4519