L322 Range Rover Service Procedures
DRIVESHAFTS
REPAIRS
47-1
DRIVESHAFTS
REPAIRS
Drive shaft - front - LH
$% 47.10.01
Remove
1. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel.
3. Release drive shaft hub nut stake.
4. With an assistant applying brakes, remove and
discard drive shaft hub nut.
5. Remove brake disc.
6. Release ABS sensor lead from clip.
7. Release sensor lead from damper, remove
Allen screw and release ABS sensor from hub.
8. Remove and discard nut securing track rod ball
joint to steering arm.
9. Fit an M14 nut to ball pin, flush with end of pin.
10. Using LRT-57-036 separate ball pin from
steering arm. Remove M14 nut and release ball
pin from steering arm.
CAUTION: Ensure ball joint seal is not
damaged. A damaged seal will lead to
premature failure of the joint.
11. Remove nut securing height sensor link to
lower arm and release link.
CAUTION: Use an open ended spanner on
flats provided to prevent ball joint rotating.
12. Loosen bolt securing lower arm to subframe
one quarter of a turn.
13. Remove nut securing lower arm ball joint to
hub.
M47 0412
M54 0179
LRT-57-036