L322 Range Rover Service Procedures
CHARGING AND STARTING
REPAIRS
86-1-3
14. Remove 6 bolts securing alternator, remove
harness securing clip and remove alternator.
Discard alternator 'O' ring.
Refit
1. Clean alternator and engine timing gear cover
mating face.
2. Lubricate and fit new 'O' ring to alternator.
3. Position alternator to casing, fit bolts securing
alternator and tighten to 13 Nm (10 lbf.ft).
4. Connect battery lead to alternator and tighten
nut securing battery lead to alternator to 13 Nm
(10 lbf.ft).
5. Secure battery lead into securing clip on engine
timing cover.
6. Connect multiplug to alternator.
7. Secure alternator harness into securing clip on
alternator.
8. Fit charcoal canister purge control valve and
connect pipe.
9. Connect radiator top hose to coolant pump and
alternator and secure clips.
10. Connect top hose to radiator and secure with
clip.
11. Fit ancillary drive belt tensioner.
REPAIRS, Tensioner - ancillary drive belt -
V8.
12. Fit viscous coupling.
13. Connect battery earth lead.
14. Fill cooling system.
ADJUSTMENTS, Coolant - drain, flush &
refill.
Ancillary drive belt - Td6
$% 86.10.03
Remove
1. Remove compressor drive belt.
Drive belt - compressor - Td6.
2. Remove viscous coupling.
3. Using a 24 mm socket, rotate tensioner
anticlockwise and remove belt from coolant
pump pulley, relax tensioner.
4. Release and remove ancillary drive belt from
remaining pulleys.
Refit
1. Check drive belt pulleys are damage free.
2. Ensure compressor pulleys and drive belt are
clean.
3. Position ancillary drive belt to pulleys.
4. Rotate tensioner anticlockwise, fit belt and
release tension. Ensure drive belt is correctly
aligned to pulleys.
5. Fit viscous coupling.
6. Fit compressor drive belt.
Drive belt - compressor - Td6.
M86 5651