LR2 (LF) L6-3.2L (2008)
9. Remove the accessory drive component bracket.
10. NOTE: Do not disassemble further if the component is removed for access only.
Remove the dowels.
Installation
1. Install the dowels.
2. NOTE: It is only necessary to check the alignment of the bracket if the bracket has been replaced, or any of the components it mounts to have
been adjusted or replaced.
Check the alignment of the bracket using the special tool.
Special Service Tools: Aligner, A/C Bracket
3. Install the accessory drive component bracket.
Torque:
M10. 50 Nm
M8. 24 Nm
4. Install the A/C compressor.
Torque:
25 Nm
5. Install the accessory drive belt.
6. Install the A/C compressor, lower support bracket.
Torque:
25 Nm
7. Install the A/C compressor, upper support bracket.