LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-628002.png)
^
Clean the component mating faces.
^
Tighten the new bolts to 45 Nm (33 ft. lbs.), then a further 60 degrees.
2. Install the engine mount bracket.
^
Clean the component mating faces.
^
Tighten the bolts to 80 Nm (59 ft. lbs.).
^
Remove the engine support.
3. Connect the starter motor cable.
^
Tighten the nut to 10 Nm (7 ft. lbs.).
^
Install the terminal nut insulator.
^
Install the cover.
4. Install the exhaust manifold.
5. Connect the battery ground cable.
