LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1956004.png)
Installation
1. Install the temperature blend door actuator.
^
Tighten the screws.
^
Connect the electrical connector.
2. Install the driver side footwell duct.
^
Tighten the screws.
3. Install the instrument panel driver side reinforcement.
Passenger Side Temperature Blend Door Actuator
Passenger Side Temperature Blend Door Actuator
Removal
1. Remove the glove compartment.
2. Remove the passenger side closing trim panel.
^
Release the clip.
^
Remove the 2 screws.
^
Disconnect the electrical connector.
3. Remove the passenger side footwell duct.
^
Remove the clip.
4. Remove the passenger side footwell duct elbow.
