Range Rover (LM) V8-4.4L (2009)
Brake Master Cylinder: Service and Repair
Brake Master Cylinder - Vehicles With: Standard Brakes
Brake Master Cylinder - Vehicles With: Standard Brakes
Service Repair No - 70.30.08
Removal
1. Remove the brake fluid reservoir.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
2. Remove the brake master cylinder.
^
Disconnect the 3 brake pipes
^
Remove and discard the 2 nuts
^
Remove and discard the seal
Installation
WARNING: Make sure that new nuts are installed.
1. Install the brake master cylinder.
^
Clean the component mating faces
^
Install a new seal
^
Tighten the nuts are 26 Nm (19 ft. lbs.)
NOTE: Remove and discard the blanking caps
2. Connect the brake pipes.
^
Tighten the nuts to 14 Nm (10 ft. lbs.)
3. Install the brake fluid reservoir.
Brake Master Cylinder - Vehicles With: High Performance Brakes
Brake Master Cylinder - Vehicles With: High Performance Brakes
Service Repair No - 70.30.08
Removal
1. Remove the brake fluid reservoir.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
2. Remove the brake master cylinder.
^
Disconnect the 3 brake pipes
^
Remove and discard the 2 nuts
^
Remove and discard the seal