landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Squeaks And Rattles - Repair Procedures|Page 6361 > < Squeaks And Rattles - Repair Procedures|Page 6359
Page 4
background image

2.

Install the three rubber pads (NTC7294) as shown in Figure 5.

3.

Refit the spare wheel.

Rear Lower Tailgate Rattle

1.

Remove Rear Fog Guard Lamp as described in section 86 Electrical of the Workshop Manual.

2.

Fit two rubber buffers (SJ5003) to each fog guard lamp as shown in Figure 6.

3.

Refit lamp and tailgate board.

Alarm Receiver

1.

Locate the alarm receiver. Refer to Section 86 Electrical of the Workshop Manual.

2.

Unscrew receiver.

3.

Place small length of foam tape on the underside of the receiver.

4.

Reinstall the receiver and trim panel.

Dashboard Vent

1.

Remove center dashboard vent as described in section 86 Electrical of the Workshop Manual.

Squeaks And Rattles - Repair Procedures|Page 6361 > < Squeaks And Rattles - Repair Procedures|Page 6359