Range Rover (LP) V8-4.0L (1999)
2.
Disconnect the ABS Modulator connector (C0506).
3.
Inspect the ABS connector for corrosion at the ground wires (Cavity 1 and Cavity 5)
4.
Inspect other wires in connector for signs of corrosion.
5.
Inspect the ABS Modulator pins for signs of corrosion.
6.
If ABS Modulator pins are corroded, clean the pins or if severely damaged, replace the modulator.
7.
If only the connector ground wires are corroded go to "Install New ABS Connector Ground Leads" repair below.
8.
If multiple connector wires are contaminated including the ground wires go to "Install new ABS Connector/Repair Harness" repair and replace
entire connector, ground wire and splice all other harness wires.
INSTALL NEW ABS CONNECTOR GROUND LEADS
NOTE:
GTR lookup sequence is as follows:
GTR Home > NAS > Service Information/ LM Range
Rover/2005 > Electrical Library. Then enter "C0362"
into the search window. Click "Document Content"
and click on Search. Select Electrical Library and
view found Connector Details.
1.
Disconnect the ABS modulator ground eyelet at C0362. (Figure 1)