Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1249002.png)
4. Remove the catalyst monitor sensor electrical connector heat shield.
^
Remove the 2 bolts.
5. Using the special tool, remove the catalyst monitor sensor.
^
Release the wiring harness.
^
Disconnect the electrical connector.
Installation
1. Using the special tool, install the catalyst monitor sensor.
^
Clean the components.
^
Apply an anti-seize compound to the thread of the sensor.
^
Tighten the catalyst monitor sensor to 45 Nm (33 ft. lbs.).
^
Connect the electrical connector.
^
Attach the wiring harness.
CAUTION:
^
Make sure the anti-seize compound does not contact the catalyst monitor sensor tip.
^
Make sure the catalyst monitor sensor wiring harness is not twisted more than 180 degrees and is not in contact with either the
