Range Rover Classic
CHASSIS AND BODY
25
REPAIR
FRONT DOOR LOCK, OUTSIDE AND INSIDE
DOOR RELEASE HANDLES
Service repair no - 76.37.12
Remove
1. Remove trim panel.
See Front Door Trim
Panel
2. Remove plastic vapour barrier sheet.
3. Remove window lift motor.
See ELECTRICAL,
Repair, Window Lift Motor - Front Door
4. Remove door glass and regulator.
See Front
Door Glass and Regulator
5. Remove door lock actuator.
See ELECTRICAL,
Repair, Front Door Actuator Unit
6. Disconnect control rod from key operated lock.
Release metal clip at bottom of rod.
7. Disconnect control rod from outside door release
handle.
8. Disconnect rod between door release handle
and door lock by releasing clip and pulling rod
out of connecting block.
9. From inside door remove pin which secures
quadrant to inner panel. Remove quadrant.
10. Remove screws securing sill button to door.
Remove sill button from control rod.
11. Remove door lock by removing three screws as
shown.
12. Withdraw lock through cut out below.
Continue for removal of outside release handle.
13. Remove nuts, shakeproof washers and retaining
bracket.
14. Remove door release handle from outer panel.
Continue for removal of inside release handle.
15. Remove screws securing handle to door panel.
16. Withdraw handle with connecting rod attached.
Refit
17. Reverse removal procedure. 1 to 16.
