ES 350 V6-3.5L (2GR-FE) (2007)
D.
Tighten the 8 bolts in the order shown.
Torque: 16 N*m (163 kgf*cm, 12 ft*lbf)
3.
Install the camshaft bearing cap (for bank 2).
A.
Apply engine oil to the camshaft journals, camshaft housing, and bearing caps.
B.
Install the No. 3 camshaft and No. 4 camshaft to the camshaft housing LH.
C.
Note the marks and numbers on the camshaft bearing caps and place each in the proper position and direction.
D.
Temporarily tighten the 8 bolts in the order shown.
Torque: 10 N*m (102 kgf*cm, 7 ft*lbf)
4.
Install the camshaft housing sub-assembly LH.
A.
Make sure that the valve rocker arm is installed as shown.