GS 350 RWD V6-3.5L (2GR-FSE) (2007)
27.
Install the No.1 air cleaner inlet with the bolt and clip.
Torque: 5.0 N*m (51 kgf*cm, 44 in*lbf)
28.
Connect the cable to the negative (-) battery terminal.
Torque: 5.4 N*m (55 kgf*cm, 48 in*lbf)
29.
Check for fuel leaks.
A.
Connect TIS Techstream to DLC3.
NOTE
Switch OFF all accessories and A/C before connecting the Techstream tester.
B.
Turn the engine switch ON (IG). Do NOT start the engine.
C.
Enter the following menus:
Powertrain / Engine / Active Test / FUEL PUMP / SPD.
D.
Check for fuel leaks.
Check that there are NO fuel leaks anywhere in the system. If there is a fuel leak repair or replace parts as necessary.
30.
Check for engine oil leaks.
31.
Check the ignition timing.
A.
Warm up the engine and then stop the engine.
NOTE
A warmed up engine should have an engine coolant temperature of over 176°F (80°C), have an engine oil temperature of 140°F (60°C),
and the engine rpm should be stabilized.
B.
Start the engine and maintain engine rpm at idle speed.
C.
Enter the following menus on TIS Techstream:
Powertrain / Engine / Data List / IGN ADVANCE.
Ignition timing: 5 to 15° BTDC at idle
HINT
Refer to the TIS Techstream Help menu for further details.
D.
Check that ignition timing advances as engine speed increases.